Hardware Forums - View Single Post

rabbitiswise · 30-07-2008, 09:11 PM

Reset the jumpers on your master IDE then check and see if your slave is set slave. Or you can set both to CS (Cable select) and then set the drives on the right part of the IDE cable. If your still a no go. Set the drive master and put it alone and see if the bios sees it. If it does your doing something on the jumpers.

30-07-2008, 09:11 PM	#3 (permalink) Top
rabbitiswise Geek Trainee Join Date: Jul 2008 Posts: 6 Times Helpful: 2 Status: Offline	Reset the jumpers on your master IDE then check and see if your slave is set slave. Or you can set both to CS (Cable select) and then set the drives on the right part of the IDE cable. If your still a no go. Set the drive master and put it alone and see if the bios sees it. If it does your doing something on the jumpers.