Power Tree "S600B" UPS and Communication interface port

Discussion in 'Power Supplies and UPS's' started by arunmir, Dec 22, 2006.

  1. arunmir

    arunmir Geek Trainee

    Likes Received:
    0
    Trophy Points:
    0
    I have a Power Tree "S600B" UPS. It have a 9 pin Communication interface port. Can I connect it with computer for automatic shutdown and management? If yes where could I get driver for it.

    Note:A driver CD is included with Power Tree "RUPS 2000"; But no CD is included with Power Tree "S600B" UPS.

    I think this Communication interface port is a dummy:O
     
  2. Big B

    Big B HWF Godfather

    Likes Received:
    145
    Trophy Points:
    63
    I'm not able to dig up much, but the little that I am finding suggests that your assumptions are correct. It doesn't appear to have any sort of automatic shut-down mechanism, so that serial port is likely for show. It might be worth a shot to connect a 9-pin serial cable from the UPS to your system. Windows may have a built-in driver for it, or support it with a generic UPS driver.
     

Share This Page