Connection from PC to router

I want to connect my PC to my router with an RJ-45 cable. But do I need a cross-over cable or a straight cable?
[ot]You wouldn't expect me to ask this, but I forgot [/ot]

 

i forgot too, however, if you are connecting to your router through a hub or your routers integrated switch you use a crossover (if it has an integrated switch) & if your system is connecting directly to the router you use a straight thou :unsure: (i think)[ot]i'd forgot, & had to do a bit of research[/ot]

 

It's a Belkin N1 Wireless Router with some RJ-45 plugs. Not sure if it has a switch integrated.

 

if it has more than 1 RJ45 socket, it has an integrated switch[ot]unlike my old router[/ot]BTW: still using it, usually, there are 3, 4, or 5 RJ45 sockets on an integrated switch, so, try a crossover first & cross your fingers, & cross everything else you can cross

 

Thanks
Then I'll try a cross-over cable first.

 

After reading in my CCNA book, I discovered the following:
When connecting devices that are the same (router to router, switch to switch or PC to PC), you use a cross-over cable. In all other cases (PC to modem, PC to router, router to switch, PC to switch), you use a straight cable.

 

yes, but, you are connecting a PC to an integrated switch, you can't actually connect you PC directly to the router, because, the router is connected to the integrated switch inside itself. . . hang on . . . am i right or wrong. . . erm . . . erm . . .i was wrong, sorry, thank you for correcting me

 

No problem
[ot]I appreciate that you help me. Even if it's not fully correct, you are actually trying[/ot]

 

Use a standard RJ45 ethernet cable to connect a PC to a router.

You would only use a crossover cable if you wanted to connect a PC directly to another PC.

 

Yeah I thought so, but I was confused (forgetting loads of important stuff)