Yes.
Sure is :) I think i'll just install a PCI network card temporarily to do it and then remove it afterwards. Thanks all.
Already tried that AT :) When i do it, it says it needs access to the net to get some missing software or something. And becuase my integrated...
Yep, the card will do great in your rig. A big improvement over the 9100 for sure. Good choice :good:
It should be good enough, yes. As long as it has a good airflow rating, which it should.
Yep.
This is just like the Power supplies Amps vs. Watts deal. In fans, the same applies except with Airflow vs. Fan speed. You could have a 8cm fan...
Hi all, After searching the net for hours and trying almost every method possible to install DSL on my 512MB pen drive, nothing has worked :(...
Yep, sounds like either a power drain or a bad Inverter. If you've got an old PSU lying around, run the Cathode off that.
Yep, both work for me too.
It's a pretty good cooler for it's price. All copper, fan speed control....Although the fan may be a bit loud due to the fan grill it uses.
You could also try DriveScrubber. It's a free trial but since you'll only be using it a few times, i don't see the harm.
Addis pretty much nailed it. The 6800 has 256bit mem interface which is better for high resolutions, AA & AF, and has the possibility of...
This post may help you.
I think this has been suggested before. As i remeber, the feature was abandoned previously but may be added as a 'Premium' feature. As for the...
I would booting into VGA mode by pressing F8 at system boot. From there, set the resolution to 800x600 and the Refresh rate to 60Hz. After all...
Having AA on will always be a resource hog, no matter what settings are used. My recommendation is to just experiment with different setting and...
Yes, Anti-Aliasing will remove the jaggies. If you compare my screenshots, look closely at sam's right arm. You'll notice everything that has an...
If it's possible, i'd try the new printer on another PC and see if the same problem arises.
Hello and welcome :cool: It sounds as though a USB specific setting in your BIOS has been incorrectly set. I'm not a 100% positive on this but...
Separate names with a comma.
